Bubble film manufacturing process: By continuously developing and independent innovation, the company generally absorbs the technology of countries around the world. Its overall design has been studied and is easy to use and effective. The bubble film machine can be used by raw materials: This device can be used to recycle LDPE and LLDPE plastic. The finished product can replace the paper version of the envelope bag, paper plastic composite packaging bag, pearl cotton and other packaging products. Environmental protection, moisture -proof, and anti -crushing formation. For furniture, hardware, electronic equipment, machinery and equipment, etc. How to regulate the operation of our bubble film machine, let me briefly introduce it:
1. Make sure that there is no problem with automatic temperature control, and there is no problem with the heater. Pay attention to adjust the heating temperature of each point in time within the scope of the indicator.
2. Check the traction speed and control the thickness of the paint film.
3. Observe the uniformity of adjusting the thickness of the membrane, and whether the diameter meets the standard.
4. Check the pressure of the storage cylinder. It should not be too high, but it requires additional pressure.
5. Control the raw material ratio and mix well.
6. Check whether the raw materials have impurities. Especially to ensure that iron and magnets are mixed in time.
7. Check the position of the gear box and the lubrication of the air pressure machine.
8. Regularly check the transmission of each motor in the operation and the bubble film machine.
After maintenance, what impact of the bubble film will have on the later work?
1. Check the power supply, vacuum system, air pressure system and cooling system before each startup. After the device is started, check whether the rotation direction of each rotating part is correct. Pay attention to check the lubrication of each lubricant. Electric instruments should be maintained normally in accordance with regulations.
2. The device must have a special person to operate. Do not let the extruder screw no longer empty, so as not to scratch the screw and barrel. After stopping, if there is material storage in the barrel, before starting again, the temperature of each temperature area must be raised to the specified requirements according to the process requirements, and it must be kept for more than 30 minutes before starting. It is strictly forbidden to start before the temperature does not meet the requirements to avoid damaging parts.
3. When entering the feed in the fight, keep it clean to strictly prevent metal debris, sand and small tools from entering the feed inlet, so as not to damage the cylinder and screw. If abnormal noise is found during operation, it should be stopped immediately.
