Full automatic air bubble film manufacturer: This series of bubblers can use raw materials to produce single -layer or double bubble film machines between 500 mm and 1800 mm. The main products of the bubble film machine include full -automatic high -speed bubblers, high -speed bubble film machines, polyethylene composite bubble film molding machines, double bubble film machines, multi -layer bubble film machines and other bubble film machine equipment.
Fully automatic bubble film machine manufacturer: After maintenance, what will the bubble membrane opportunity affect the later work
1. Check the power supply, vacuum system, air pressure system and cooling system before each startup. After the device is started, check whether the rotation direction of each rotating part is correct. Pay attention to check the lubrication of all lubricants, and the electrical instrument should be maintained normally as required.
2. The equipment shall be operated by specialized personnel. Do not let the squeeze screw turn around without material, so as not to scratch screws and barrels. After stopping, if there is material storage in the barrel, before starting again, the temperature of each temperature area must be raised to the specified requirements according to the process requirements, and it can be maintained for more than 30 minutes to start. It is strictly forbidden to start before the temperature does not meet the requirements to avoid damaging parts.
3. When entering the feed in the fight, it must be kept clean. It is necessary to strictly prevent metal impurities, sand, and small tools from entering the materials to avoid damaging the cylinder and screw. If any abnormal noise is found during operation, stop the machine immediately.
Full automatic air bubble film manufacturer: daily maintenance method of film blower
What are the daily maintenance methods of the film blower? Any machine requires appropriate maintenance, just like the regular maintenance of ordinary cars, so the maintenance of the film blower is particularly important. Normal maintenance operations should be concentrated in the following aspects:
1. Place the sealing machine on the ventilated hard land, and keep the room temperature at 25.
2. Every two days, all motion components, especially gears, bearings, and gear boxes, should be added with No. 6 oil.
3. Dust dust in time and keep the whole machine clean. Do not pull off or drop the power during the production process, cover the power with cloth.
4. If the running time is too long, open the cooling fan before closing, and then close it after the temperature drops.
5. High -temperature zone should be removed in time to remove dust and dirt to ensure the quality of sealing.
6. Severe wear parts should be replaced in time to extend the service life of the entire machine.
