How to prevent bubble film bag making machine? In order to make the bubble film bag making machine work more efficiently, we should do a good job in the corresponding prevention before using the bubble film bag making machine to avoid equipment failure and failure to continue operation. The production efficiency is affected. Let's take a look!
The bubble film produced by the bubble film bag making machine can effectively protect the products, so it has been widely used in many industries. Because the bubble film has good performance, it can provide good protection for all kinds of products, and high-quality bubble film is often made by the bubble film bag making machine. How to solve problems in the production process? How can we do a good job in prevention? The bubble film bag making machine shall be operated by a specially assigned person. It is not allowed to idle the extruder screw without material to avoid scratching the screw and the barrel. After shutdown, if there is material stored in the barrel, before restart, the temperature of each temperature zone must be raised to the specified requirements according to the process requirements, and the machine can only be started after holding for more than 30 minutes. It is strictly prohibited to start the machine before the temperature reaches the requirements, so as not to damage the machine parts. When the air cushion film machine is feeding into the hopper, it must be kept clean, and metal debris, sand and small tools must be strictly prevented from entering the feed opening to prevent damage to the barrel and screw. If abnormal noise is found during operation, it should be stopped immediately for treatment. In order to avoid this kind of failure, it is very important for us to do a good job in the maintenance of the bubble film bag making machine. The screw of the air cushion film machine should be properly treated to prevent deformation when it is taken out of the barrel for some reason. If it is not installed back into the barrel for a long time, the screw must be vertically hung to prevent bruise, bending and permanent deformation. The barrel and screw surfaces should be coated with antirust oil for protection. After the bubble film bag making machine is shut down, if there is material stored in the barrel, the temperature of each temperature zone must be raised to the specified requirements according to the process requirements, and the machine can only be started after holding for more than 30 minutes. It is strictly prohibited to start the machine before the temperature does not meet the requirements, so as not to damage the machine parts. The bubble film bag making machine shall be overhauled regularly, the die head shall be thoroughly cleaned every three months, the lubricating grease of various bearings shall be replaced, the lubricating oil of the reducer shall be replaced every six months, and the overall equipment shall be overhauled every two years.
