What are the operating points of the bubble film machine? What are the industrial applications of bubble film machine? We should pay extra attention to the use. Now let's look at the operating points of the bubble film machine.
1. It is important that when operating the machine, the operator should not stand in front of the machine, so as to avoid accidents to the machine and damage to the operator. In addition, during feeding, it is strictly prohibited to transfer metal impurities and other hard objects that may damage the machine into the barrel. While operating the rotating machine, it is prohibited to wear gloves to prevent injury caused by being involved in the machine.
2. Before operation, check and add the lubricating oil in the reduction gearbox and air compressor, and check the lubrication of the mechanical rotating parts to avoid damage to the machine and noise caused by too dry parts. At the same time, it is necessary to check whether the wiring of each power supply is disconnected, electric leakage, and whether the instrument is damaged. Before operation, it is necessary to ensure that all components are safe and normal, so as to avoid production accidents.
Bubble film machine
3. The molding temperature, cooling air temperature and blowing expansion ratio shall be increased within the film forming conditions. And when the discharge of the membrane buckle is uniform, it is necessary to wear gloves to slowly lift the tube blank, close the port at the same time, slightly open the air inlet regulating valve, so that a small amount of compressed air is put into the central hole of the mandrel, and then carefully guide it through the foam stabilizer, herringbone plate, and through the traction roller, guide roller until coiling. The compressed air pressure of the expanded tube blank should be appropriate, which can not break the tube blank, but also ensure the symmetry and stability of the membrane tube, and relatively ensure the quality of production.
4. After the operation is completed, when it is necessary to clean the extruder and die mouth, you can use a copper knife, rod or compressed air for cleaning, but do not damage the surface of the screw and the screw, and keep the surface smooth and clean.
