How to do preventive work for bubble film bag making machine? In order to make the working efficiency of bubble film bag making machine higher, we should do corresponding preventive work before using bubble film bag making machine to avoid equipment failure and inability to continue operation. Affecting production efficiency, let's take a look at it together!
The bubble film produced by bubble film bag making machine can effectively protect the product, so it has been widely used in many industries. Because the bubble film has good performance and can provide good protection for various products, and high-quality bubble film is often made by bubble film bag making machine. How to solve the problem if there is a fault in the production process? How can we do preventive work? A special person should be assigned to operate the bubble film bag making machine. The extruder screw is not allowed to run idle without material to avoid scratching the screw and the barrel. After stopping, if there is material in the barrel, before starting again, the temperature of each temperature zone must be raised to the specified requirements according to the process requirements, and the machine can be started after keeping warm for more than 30 minutes. It is strictly forbidden to start the machine before the temperature reaches the requirements to avoid damage to the machine parts. When feeding the air cushion film machine into the hopper, it must be kept clean and prevent metal debris, sand and small tools from entering the material port to prevent damage to the barrel and screw. If any abnormal sound is found during operation, the machine should be stopped immediately for processing. In order to avoid this kind of failure, it is very important for us to do a good job of maintaining the bubble film bag making machine. If the screw of the air cushion film machine is taken out of the barrel for some reason, it should be properly handled to prevent deformation. If it is not put back into the barrel for a long time, the screw must be hung vertically to prevent bruises, bending and permanent deformation. The surface of the barrel and screw are coated with anti-rust oil for protection. After the bubble film bag making machine is stopped, if there is material in the barrel, before starting the machine again, the temperature of each temperature zone must be raised to the specified requirements according to the process requirements, and the machine can be started after keeping warm for more than 30 minutes. It is strictly forbidden to start the machine before the temperature reaches the requirements to avoid damage to the machine parts. The bubble film bag making machine should be regularly inspected and maintained, the die head should be thoroughly cleaned every three months, the grease of various bearings should be replaced, the lubricating oil of the reducer should be replaced every six months, and the entire equipment should be overhauled every two years.
