Bubble film machine is a well-known packaging artifact in the rapid development of the express industry society.As more and more people see the business opportunities in this industry, there have been many entrepreneurial bubble film machine manufacturers in recent years, and the demand for bubble film machine is growing.Many manufacturers may not be familiar with the use of bubble film machine steps, today to share.
Bubble film machine correct operation process:
1. Before starting, the temperature of each temperature zone must be raised to the specified requirements according to the process requirements, and kept for more than 30 minutes to start.It is strictly forbidden to start before the temperature does not meet the requirements, so as not to damage the bubble film machine.
2. The products produced by bubble film machine are moisture-proof, shock-proof, sound-proof, beautiful, insect-proof, mildew-proof and cheap.Therefore, when feeding in the hopper, we must keep it clean and strictly prevent metal debris, sand and small tools from entering the feeding mouth, so as not to damage the cylinder and screw.If any abnormal noise is found during operation, it should be stopped and dealt with immediately.
3. Check whether the temperature control of the bubble film machine is good, whether the heating device is in good condition, and whether the temperature of each point is within the index range to ensure the normal operation of the machine.
4. Observe whether the film thickness is uniform and whether the folding diameter meets the standard.If not, it needs to be replaced.
5. Regular maintenance, thoroughly cleaning bubble film machine every three months, every three months to replace the grease of various bearings.
Then, before the bubble film machine equipment is produced, we need to check and do a good job to ensure its good condition.What should we pay attention to when checking bubble film machine?
1. Check whether the temperature control and heating apparatus are in good condition, and pay attention to adjust the heating temperature of each point in time within the index range.The pressure of the gas storage tank should not be too high, but there should be spare pressure.
2. Check and control the proportion of raw materials, stirring evenly, traction speed, and film thickness.
3. Regularly check the temperature rise and mechanical transmission of the running motor of the Kunming bubble film machine and the lubrication of the cylinder lubricating oil of the reducer and air compressor.
4. Check the raw materials for impurities, especially the iron mixed with magnets to check in time.
5. Observe and adjust the uniformity of film thickness, and the folding diameter meets the standard.When the mold outlet of the bubble laminating machine is uniform, you can wear gloves and slowly lift the tube blank.At the same time, the end of the tube blank is closed, and a small amount of compressed air is pumped into the central hole of the mandrel.It was then carefully guided through the bubble stabilizer and herringbone plate, and through the traction and guide rollers until winding.Only in this way can we make better use of the Kunming bubble laminating machine, extend its service life and create more profits.
