How to operate the bubble film machine? What are the requirements when operating the bubble film machine? Now let's get to know with the bubble film machine manufacturer!
1. Before starting the machine, check whether the power supply wiring is disconnected or leaked; Check whether the instrument is damaged or abnormal. Before starting the machine, ensure that all parts are safe and normal to avoid affecting production and causing accidents.
2. Check and add the lubricating oil in the reduction gearbox and air compressor, and check the lubrication of all mechanical transmission parts. Avoid dry operation damaging the machine and making noise.
3. The compressed air pressure for expanding the tube blank shall be appropriate, which can not break the tube blank, but also ensure the symmetry and stability of the membrane tube, and relatively ensure the quality of production.
4. Within the film forming conditions, increase the forming temperature, cooling air temperature and blowing expansion ratio; Then the film turbidity increases and the glossiness decreases; On the contrary, improve.
5. When the discharge from the die mouth is uniform, you can wear gloves to slowly lift the tube blank, close the end of the tube blank, slightly open the air inlet regulating valve, so that a small amount of compressed air is put into the central hole of the mandrel, and then carefully guide it through the foam stabilizer, herringbone plate, and through the traction roller, guide roller until coiling (if embossing is required, it should pass through the embossing roller)
6. Before starting the machine, check whether the power supply wiring is disconnected or leaked; Check whether the instrument is damaged or abnormal. Before starting the machine, ensure that all parts are safe and normal to avoid affecting production and causing accidents.
Through the above introduction of the bubble film machine manufacturer, you should know what the operation requirements of the bubble film machine are!
