The bubble film machine is a well -known packaging artifact in society where the express industry is developing. As more and more people see the business opportunities of this industry, in recent years, many entrepreneurial bubble film machine manufacturers have appeared, and the demand for bubble film machines has become increasingly demanding. Many manufacturers may not be familiar with the steps of using the bubble film machine, let's share it today.
The correct operation process of the bubble film machine:
1. Before starting, the temperature of each temperature area must be raised to the specified requirements according to the process requirements, and it must be maintained for more than 30 minutes to start. It is strictly forbidden to start before the temperature does not meet the requirements, so as not to damage the air bubble film machine.
2. Products produced by bubbles, shockproof, shockproof, sound insulation, aesthetics, insects, mildew, and low price. Therefore, when adding feeding in the fight, it is necessary to keep it clean to strictly prevent metal debris, sand, and small tools entering the feed port to avoid damaging the cylinder and screw. If any abnormal noise is found during operation, it should be stopped and processed immediately.
3. Check whether the temperature control of the air bubble film machine is good, whether the heating device is intact, and whether the temperature of each point is within the indicator range to ensure the normal operation of the machine.
4. Observe whether the thickness of the film is uniform and whether the fold diameter meets the standard. If not, you need to replace it.
5. Regular maintenance, thoroughly clean the blister film machine every three months, and replace the grease of various bearing every three months.
Then, before the production of bubble film machine equipment, we need to check and do a good job to ensure its good state. What do you need to pay attention to when you check the bubble film machine?
1. Check whether the temperature control and heating appliances are intact. Pay attention to adjust the heating temperature of each point in time within the indicator range. The pressure of the gas storage tank should not be too high, but there must be spare pressure.
2. Check the proportion of raw materials, stir well, traction speed, and control the thickness of the membrane.
3. Regularly check the temperature rise and mechanical transmission of each operating motor of the Kunming air bubble film, as well as the lubrication of the reducer and the aircraft cylinder lubrication.
4. Check whether the raw materials have impurities, especially the iron mixed with magnets should be checked in time.
5. Observe the thickness of the membrane, and the folding diameter meets the standard. When the bubble layer is uniform, you can wear gloves and slowly lift the tube. At the same time, the end of the tube billet is closed and a small amount of compressed air is connected to the center of the core rod. Then carefully guide it through the bubble stabilizer and human character board, and then through the traction roller and the guide roller until the winding. Only in this way can you better use the Kunming bubble fitting machine to extend its service life and create more profits.
